Parts-Fixtures-Items to make you building & racing experience easier..................

Contact Info: scrgeo@comcast.net

Not all items are available al the time. Some are on request only.

 

   

  

  

              

Newer Items:

bulletThe Widgit: This was an original Cobra Part to make building the Jaildoor Drop arm easier. Grooved for the wire to wrap into.

$2.00/ea.

bulletJaildoor gear guard: Bent from 1/16" piano wire with a radius to fit a .900 to 1.00" motor bracket. May be fine tuned for other width brackets. Very difficult to bend a radius this tight and keep it round. We do it for you.

$1.25/ea.....6 for $5.75

bulletPiano Wire Bending Machine: This machine will make your "U" shaped main wire rails out of .078 wire, in a snap and also they will be flat. Positive pins holes to bend 1" and 3/4" main rail "U" bends. The supplied fences will allow you to also make other wire size U bends and perfect "L" bends. Base plate is 6061-T6 Aluminum, all pins are hardened and ground tool steel and bending crank is stainless steel, this tool will last. The left fence will also allow you to make duplicate JailDoor chassis rails exactly the same for multiple rails. No special size custom pins here, if you lose a pin, just chop off a 3/32 axle and you have a replacement. All of our products are racer friendly.
bullet $35.00
bulletNew Guide Tongue:  New guide tongue is made from .050 or .063 half hard brass and profiled to allow guide stops to function about 50-60 degrees each way. Can be ordered flat or in offset design.
bullet $3.00 flat $3.50 offset
bullet 

Samurai Chassis Kit: Very easy kit to build into an  RTR chassis. Base plate is very flat, no need to spend and hour plus to make it ready to cut or build. STart building the moment you take it out of the bag. Kit comes with a 1" hypoid motor bracket, guide tongue, front axle carriers, base plate and .078 main rail wire loop. Very easily built into a torsion car, as promoted by many as the way to go on tight flat tracks, easily cut for a floppy pan chassis also. Reports back from kit builders i they love the chassis and it handles like a dream.

$32.50

SAMURAI NASCAR: Same as above but with 1/2" longer pods in rear of pans.

$32.50

Body Harpoon: Made with an aluminum handle, 1/4" and overall length about 2 3/4". Easy to use and comfortable to handle. .031 harpoon will push thru the toughest bullet proofing. Knurl on end to grip, if needed. Now slot box should be without this tool.

$5.50

Crown gear bushing installation/removal tool: Makes it easy to install and remove the bushing in your crown gear. I have had trouble getting them back out after they have been run and just threw the bushing away in the gear, no more! Now those tight ones that get stuck can be tapped out easily with this tool. Same function with tight bushings, grind a small lead with your dremel to get it all started and tap into the gear. 1/8" shaft with 3/32 reduced end for bushing.

$9.95

Revised Retro Tech Tool: The tech tool has been revised and now has the correct front tire width. ( IRRA and D3 changed dimensions after initial tool was already produced to original sizes) There has also been added two more checking gauges, one for D3 F1 chassis width and another for IRRA F1 chassis width. The one end has an extended leg to make it easier to check bottom clearance in the rear. Tool is .050 thick

 

 

 

 

        HOME                 HOT ITEMS               NEW NEW                  PICTURES             DESCRIPTIONS AND TECH     CONTACT US